Welcome to fireflyprops.net. Click here to register

Dobson's Cortex device

Props from the BDM - The Big Damn Movie

Re: Dobson's Cortex device

Postby dsears30 » Mon May 09, 2016 5:33 pm

The bottom part was pushed in when done. When I took the picture I was still trimming the inside section so the part would fit in snug and the lid would still close properly. I had slid the bottom down to make it easier to work the inside, side sections, they have to be grinded/sanded down so the body fits inside the case better. This Is it when done.
Attachments
Done med.jpg
User avatar
dsears30
Independent Soldier
 
Posts: 284
Joined: Sun Jun 29, 2014 4:08 am

Re: Dobson's Cortex device

Postby monkey540 » Mon May 09, 2016 8:38 pm

Gotcha, was there a specific tool you used to cut the clip piece to the right shape? I was going to possibly use a dremmel with a plastic cutting wheel.
User avatar
monkey540
Independent Soldier
 
Posts: 150
Joined: Sat Nov 30, 2013 3:44 am
Location: Edmonton, Alberta

Re: Dobson's Cortex device

Postby dsears30 » Wed May 11, 2016 10:32 pm

It's pretty thin, so after I decided the size, I cut it with scissors, then a little sanding . Than trim the ends so it will set in there, it took a few tries but it will allow the case to close.
User avatar
dsears30
Independent Soldier
 
Posts: 284
Joined: Sun Jun 29, 2014 4:08 am

Previous

Return to Serenity

Who is online

Users browsing this forum: No registered users and 2 guests

cron